Keep the transmitter you want tuned at least 2 feet away from the power head while tuning. Press the transmitter button once more to test the system and start your door moving. Press and hold down the square button on the motor head until the round blue LED light come on, then release the square button. The long purple LED button will start to blink.
Note: if the blue light stays on, go to instructions for Intellicode III, below While the long LED is blinking, hold the remote 4 or 5 feet away and press 3, 4 or 5 times, until the door activates. Your remote is now programmed. Press the square button once more until the long purple LED comes on and release. The purple LED should be blinking.
To unlock the programming feature use a remote that already operates the unit and press it once. Purple light goes solid. Hold the new remote 4 or 5 feet away and press 3, 4 or 5 times until the door activates. The remote is then programmed Clearing Memory for Remotes and Keypad if present Follow steps 1 and 2 above or step 1 if between and July 8, This clears the receiver memory. All previously programmed remotes will no longer work with your door. To re-program each remote follow steps 1 through 3 of the programing instructions relative to your opener above.
Programming Digital Remote Transmitters with Internal Set Switches These transmitters work by matching the settings on the internal code setting switches with the same set of switches in the receiver on the garage ceiling. To program a button for one of your doors, follow the instructions below: First, match the settings on the Internal Code Setting Switches with the same set of switches in the receiver on the garage ceiling, as described in the previous programming instructions. Follow the same procedure for each additional door you wish to program.
Installation of Genie GIC Intellicode Receiver Terminals labeled 1, 2 and 3 on the Receiver are connected to their corresponding terminals on the garage door opener Power Head labeled 1, 2 and 3. The smart indicator light will glow steadily for 30 seconds. The LM and LM remotes have a corresponding amber or red, square, learn button. The LM and LM have a corresponding purple, square, learn button. Learn buttons are located on the motor head near the terminal strip for wire connections.
Within 30 seconds, press and hold the button on the hand-held remote. It has learned the code. If light bulbs are not installed, two clicks will be heard. Press the button on your remote within 30 seconds of releasing the learn button. The red LED beneath the learn button will stop flashing and remain lit. Press the remote control button once again to complete the programming and extinguish the red LED. Raise the light bulb cover on the Genie opener motor.
Secure the cover with the two screws you removed. Cecilia Harsch has been writing professionally since She writes mainly home improvement, health and travel articles for various online publications.
She has several years of experience in the home-improvement industry, focusing on gardening, and a background in group exercise instruction.
Harsch received her Certified Nurses Assistant license in She attended Tarrant County College and studied English composition.
0コメント